Article AudienceGet Your Articles Listed

There are various ways to approach carpet and upholstery cleaning. The kind of material as well as the reason you are cleaning it will determine which specific method you will use Regardless of whether you are planning on using a professional carpet cleaning service or you feel energetic enough to do it yourself, here are some of the basics on cleaning upholstery, rugs and carpets

Methods of cleaning carpets

In a nutshell there are five general methods of cleaning: hot water extraction (steam cleaning), shampooing, quick dry (bonnet), dry foam and dry absorbent compound cleaning.

Hot water extraction (steam) is often the most common of all the normally used methods but since the drying time can be up to 12 hours depending on the material, this is not always the best solution. A strong pump sprays a cleaning solution on to the carpet or rug which then gets sucked out with all the dirt by a powerful vacuum.

There are many different types of carpet shampoo machines available on the market. Many of them stand upright with a tank for the solution and a couple of nylon brushes underneath. If you can imagine somebody manually cleaning with a scrubbing brush, this is basically the same that happens with a machine. The carpet is scoured with the nylon brushes loosening the dirt which is then vacuumed up later after the carpet has dried. This method has the same unfortunate downside in that it can take over 12 hours for the carpet to dry

Quick dry cleaning uses the same equipment as normal shampooing and actually the two methods are identical in many ways. The only different is that quick dry cleaning, instead of using nylon brushes to scrub the carpet, uses a flat, absorbent pad which looks similar to a small round mop. The carpet is first sprayed with the quick dry cleaning solution before the machine buffs the carpet (think of buffing as being the same as trying to make your kitchen floor shine). The bonnet (the pad) absorbs the cleaning fluid and collects the dirt at the same time. Drying time is about an hour which is a lot more practical for high traffic areas.

Dry Foam cleaning is a mixture between shampooing and hot water extraction. Foam is introduced to the carpet by a machine with rolling brushes and the carpet is then vacuumed to remove the dirt. The drying time, dependent on the carpet type of course, is between an hour or two.

Dry absorbent compound is a powder which contains solvents and detergents, which are spread lightly on the carpet. You, or the professional you hire, uses a machine which scrubs the mixture into the carpet fibers and the carpet is left to stand for a bit. After a little wait, the vacuum cleaner is then used to suck up the compound (which has by now absorbed all the dirt) as a result the carpet stays as dry as it was when you started. This is probably the best method to use if you have thick carpets which can go moldy underneath if they stay wet for too long.

How to clean upholstery

The upholstery fabric is what normally determines what kind of cleaning method will be used. Velvets and silks, for example, can only be dry cleaned and, unless you really know what you are doing, is best left to an upholstery cleaning professional. Other more durable fabrics can be steam cleaned similar to carpets as they do not suffer any side effects from getting wet. The hot extraction method (steam cleaning) is identical to that which is used for carpets except that the nozzle is a small, hand held version. Hand shampooing can also be used but instead of using a machine the cleaning fluid is agitated into a foam and this foam is then applied to the fabric using a sponge.

Identifying the upholstery material

When it comes to cleaning fabric furniture, most people don’t know what the best method to use should be. Search for the manufacturer’s instructions label. You should find it lurking at the bottom of one or all of the cushions and this should contain the manufactures suggestions, warnings and instructions. Apart from all the other images and text, look out for one of three codes: ‘S’, ‘W’ or ‘SW’. ‘W’ indicates that wet cleaning is permissible while the ‘S’ states that the material should only be dry cleaned. ‘SW’ indicates that the material is suitable for both wet and dry cleaning methods.

Of all the industrial cleaning companies offering office cleaning contracts in the South East, only Crystal Clean Solutions will provide you with a personal touch and a wonderfull result – visit www.crystalcleansolutions.co.uk You can get a unique content version of this article from the Uber Article Directory.